Datalink Systems i50 Especificaciones descargar pdf (Pagina 31)

i50 Manual (5.10)

Page 31

www.datalinksystemsinc.com

Transparent Data

Transparent COM Speed: Transparent COM speed.

Transparent Serial Config: COM settings for transparent interface.

Transparent Config: Select whether the i50 will buffer multiple transparent packets. If

this is disabled, new transparent data will overwrite any existing

unsent data. Also has an option to attach the current time and

GPS position to each transparent packet generated. For SIGNS

firmware, this setting also contains the sign on and off times.

Pager

Pager System ID: Only Grace pager signals with a matching System ID will be

processed. Set to zero to process all pager signals.

Pager Timeout: Period of time to wait before alerting a user that a pager signal

has been lost. This time should be set greater than the pager

polling interval.

Accelerometer

Max Acceleration: Send alert when vehicle accelerates faster than this limit. Set to

zero to disable.

Max Braking: Send alert when vehicle brakes harder than this limit. Set to

zero to disable.

Max Cornering: Send alert when vehicle corners harder than this limit. Set to

zero to disable.

Max Tilt Angle: Send alert if unit is tilted over this angle. Note that the unit must

be stationary to detect a tilt angle. Set to zero to disable.

Accelerometer X/Y Angle: Amount i50 has been rotated from a level position. The X angle

indicates a rotation from front to back of device. The Y angle

describes rotation from side to side. Set to zero to calibrate

automatically.

Accelerometer Z Angle: Indicates how far the front of the device (Program connector

end) has been rotated away from the front of the vehicle in a

level plane. Set to zero to calibrate automatically. Select

“Uncalibrated” to disable calibration (no acceleration alerts will

be sent).

Motion Threshold: Set the g-force required to trigger motion detection. This is used

to detect several events, including calibration, tilt angle,

start/stop motion (if “Use Accelerometer to detect motion”

enabled), and sleep mode (if “Wake on motion” enabled).

Extra Settings

Unknown Settings: Future firmware versions may have settings that are not

supported by this programmer. These settings will be shown

here, and their values will be maintained when reading and

writing.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 64 65

Comentarios a estos manuales

Sin comentarios

Datalink Systems i50 Especificaciones Pagina 31

Comentarios a estos manuales

Relacionado con productos y manuales para Navegadores Datalink Systems i50